Door suction cleaning method

When cleaning the door, you should wipe it clean even with the door sucker. However, when wiping the door absorber, you should first dispose of the dust on its surface with a soft cloth or dry cotton yarn, and then clean it with a neutral detergent. After cleaning, wipe the moisture on the door and keep the door dry.

Maintenance method of door gripper

1. Prevent bumps in handling.

2. When cleaning, try not to wet the metal plating parts, first use a soft cloth or dry cotton yarn to remove dust, and then wipe with a dry cloth to keep it dry. Do not use colored detergents or force the surface layer.

What should I do if the door suction rusts and does not suck

1. Remove the rust spots

Whether it is a suction plate or an electromagnet that is rusty, the first thing to do is to find a way to remove these rust spots. Common ways to remove rust spots are as follows:

(1) Scrape with a knife: Use a knife or a small fruit knife that you don't use at home to carefully scrape off the rust spots on the door;

(2) Soak with vinegar: pour an appropriate amount of vinegar directly on the door sucker, or wet it in vinegar with a soft rag, then wring some out, and rub the door vigorously until the rust spots on it are gone.

(3) Sandpaper sanding: You can also use sandpaper to polish the rust spots, but you need to choose sandpaper with a more delicate texture, so that the grinding effect is better.

2. Clean the door sucker

After removing the rust spots, clean the door with a soft rag to make sure it is neat. Finally, wipe off the water stains with a dry rag.

3. Test whether the door stopper can be used normally

After the above two steps, the next thing to do is to test the door pipe. Open it to see if the suction plate and electromagnet can be sucked firmly. If you find that the door stopper still cannot be sucked after the test, you need to replace it with a new one.

4. Polishing the door sucker

If you are sure that the doorholder can be reused, you can use a professional polishing powder to polish the doorholder to make it look like new.